 |
| Repairing one of the timber bike parts. The diameter of the hole for the head tube bearing was too small, and this setup was used to fix it. |
 |
| Preparing the steel plates used to distribute stress from the head tube bearings into the frame. The holes that will carry screws needed to be enlarged and chamfered. I'm not using all the holes in the plates. |
 |
| Finishing off the frame. With this epoxy glue, I'm binding the internal frame reinforcements to the frame sides. |
 |
| Parts stored under cover at the end of the day. One side of the frame has been glued and the prepared steel plates have been painted ready to be attached to the frame. |
Hi
Pictures tell the story today.
Regards
Steve Nurse
Posts
No comments:
Post a Comment